LYDY加藥裝置中加藥泵電機發熱卡死轉不動的原因
LYDY加藥裝置在使用中，經常發現加藥泵電機發熱不工作。電機故障的主要原因如下：
1、馬達轉向不正確，導致泵內部零件卡住
2、泵的內部驅動部件卡住，導致電機過載
3、泵液壓端內部壓力過大，導致電機過載
4、環境溫度過低，加藥裝置的加藥泵內潤滑油粘度過高，導致電機過載
相應的解決方案如下：
1、更換馬達接線并調整馬達轉向
2、檢查泵驅動箱的內部并更換有故障的零件
3、斷開LYDY加藥裝置加藥泵進出口管，釋放計量泵內部壓力
4、更換潤滑油牌號。
成套加藥裝置加藥泵使用時電機發熱原因分析
1、潤滑油油位過低，導致運動部件潤滑不足，部件過熱
2、潤滑油牌號不對
3、聯軸器和電機適配器之間的摩擦
4、加藥裝置加藥泵的電機轉子和定子之間出現間隙
相應的解決方案如下：
1、加潤滑油至規定油位，以保證潤滑效果
2、更換正確牌號的潤滑油
3、調整堿液加藥泵聯軸器安裝位置，避免摩擦
4、修理馬達。
The cause of heating and sticking of the dosing pump motor in lydy dosing device
Lydy dosing device in use, often found that the dosing pump motor heating does not work. The main causes of motor failure are as follows:
1. The incorrect steering of the motor causes the internal parts of the pump to get stuck
2. The internal drive part of the pump is stuck, causing the motor to overload
3. The internal pressure of the hydraulic end of the pump is too high, resulting in the overload of the motor
4. When the ambient temperature is too low, the viscosity of the lubricating oil in the dosing pump of the dosing device is too high, resulting in the overload of the motor
The corresponding solutions are as follows:
1. Replace the motor wiring and adjust the motor steering
2. Check the inside of the pump drive box and replace the faulty parts
3. Disconnect the inlet and outlet pipes of lydy dosing device dosing pump to release the internal pressure of metering pump
4. Change the brand of lubricating oil.
Cause analysis of motor heating of dosing pump in complete dosing device
1. The lubricating oil level is too low, resulting in insufficient lubrication of moving parts and overheating of parts
2. Wrong brand of lubricating oil
3. Friction between coupling and motor adapter
4. There is a gap between the motor rotor and stator of the dosing pump of the dosing device
The corresponding solutions are as follows:
1. Add lubricating oil to the specified oil level to ensure the lubricating effect
2. Replace the correct brand of lubricating oil
3. Adjust the installation position of alkali dosing pump coupling to avoid friction
4. Repair the motor.